ATZ Small Form Factor Pluggable (SFP) transceivers are compatible with the Small Form Factor Pluggable Multi-Sourcing Agreement (MSA).The transceiver consists of five sections: the LD driver, the limiting amplifier, the digital diagnostic monitor, the 1310nm FP laser and the PIN photo-detector .The module data link up to 80KM in 9/125um single mode fiber.
The optical output can be disabled by a TTL logic high-level input of Tx Disable, and the system also can disable the module via I2C. Tx Fault is provided to indicate that degradation of the laser. Loss of signal (LOS) output is provided to indicate the loss of an input optical signal of receiver or the link status with partner. The system can also get the LOS (or Link)/Disable/Fault information via I2C register access.
Features:
- AutoCross™: Automatically detects and configures the twisted pair port on the converter to the correct MDI or MDI-X configuration.
- Link Pass Through: Link Pass Through is a troubleshooting feature that allows the media converter to monitor both the fiber and copper RX ports for loss of signal.
- Automatic Link Restoration: The media converters will automatically re-establish link in all network conditions.
- Selectable speed setting: The converter can be set to 10Mbps or 100Mbps or 1000Mbps . Both copper and fiber ports are automatically set to the same speed. Devices connect to duplex mode of link partner. Jumbo Frames is available for the 10/100/1000M media converter with 1 RJ45 port + 1 fiber port.
- 10/100/1000Mbps auto-negotiation Supports IEEE 802.3x full-duplex flow control and back pressure half-duplex flow control
- Supports MAC self-learning Standards: IEEE802.3, IEEE802.3u, IEEE802.3x, 10/100Base-TX, 100Base-FX, 10/100/1000Base-TX, 1000Base-FX/LX LED status of Link, activity, Full/half duplex, speed and power on diagnostic function Extremely low power consumption and low heat Reliable and stable performance
